Whether it’s office IT, refrigerators or machinery, the maintenance and efficient use of equipment can make a big difference to your energy bills.

Here are our top tips for saving energy at low or no upfront cost:

1. Ensure equipment is switched off when not in use

This sounds obvious, but it’s often overlooked for regularly-used equipment that can be left in an idle state – think of printer copiers and PC monitors in offices or manufacturing machinery that is left on despite only being needed some of the time.

  • Fact: A manufacturer in Oldham achieved annual energy savings of over £12,500 by switching off shrink-wrap machinery that was left running continuously despite being unused 30 per cent of the time. An engineering firm in Bolton saved £2,400 just by switching off a small process oven between cycles.
  • Myth buster: Leaving IT equipment on standby is not a good way to save energy – each little red dot still costs money.
Fridges

Turning off equipment that isn't in use is an overlooked way for a business to save energy. 

Image: Getty Images

2. Service and maintain air conditioning units

Air handling systems will clog up over time, which reduces their efficiency. Make sure filters are replaced and the equipment is serviced regularly.

  • Fact: The cost of servicing air handling equipment will easily pay for itself two or three times over before the next service.

3. If you have refrigeration equipment...

Check the rubber seals on doors and replace those in bad condition – damaged seals waste energy.

  • Tip: If possible, any fridges or vending machines that are near to a direct heat source should be moved.

4. Maximise the use of space in refrigeration

Consider whether you can consolidate items into fewer fridges or freezers, but make sure air can still circulate. It’s also important to regularly defrost freezers to ensure good circulation.

  • Tip: If you have refrigerators or vending machines that only contain non-perishable goods, install low cost timers so they automatically switch off outside of operating hours.

5. If you’re a manufacturer, walk around your site and listen out for compressed air leaks

Air leaks waste huge amounts of energy and can be easily fixed. It’s also good practice to check the pressure and investigate whether it can be reduced without affecting your process – just a 10% reduction could generate 5% energy savings.

  • Fact: A single pinhead leak in a compressed air system could now be costing up to £2,000 a year in wasted energy.

6. Establish the optimum setting for all motors and ensure they are kept clean and regularly serviced 

Dirty equipment runs hotter, will operate at a lower efficiency and is much more likely to break down or seize up.

  • Fact: Reducing the speed of a motor by just 20% can halve its energy consumption.

Need support?

If you are seeking a trusted, local supplier for installing energy-saving technologies, use our online marketplace. 

Energy efficiency is also a key element of our popular Journey to Net Zero programme for Greater Manchester SMEs. Visit businessgrowthhub.com/netzero

This blog was originally published on the Bee Net Zero website.

Read our series of blogs to help you reduce energy in your business. 

Share this case study

Green Economy Master Logo RGB

Green Economy

Green Economy

Building a greener, net zero economy powered by local suppliers.